B19A7 Gmc Yukon Diagnostic Trouble Code

B19A7 Gmc Yukon code definition:
B19A7 is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Gmc Yukon.

B19A7 Gmc Yukon is defined as Cylinder 3 Injector Circuit Malfunction. This code means the PCM (powertrain control module, also known as ECM or engine control) has detected a problem in the injector or its wiring, or in injector circuit for cylinder 3. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a B19A7 Gmc Yukon diagnostic trouble code may include:

Faulty PCM
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.
Poor acceleration
Rich or lean exhaust

Possible Causes :

The Mass Airflow sensor will also cause this problem. Mass Airflow circuit malfunction.
Fuel with a large percentage of sulfur will clog the DPF quickly
A large air leak at or near the number one oxygen sensor would also cause a lean mixture.

Common Misdiagnoses

Exhaust Gas Recirculation System Valve 1 Problem
BBV Sensor Circuit Low Voltage Problem
Transmission Engaged At High Throttle Angle Problem
Cruise Inhibit Control Circuit Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem

Repair Processes :

Find out what kind of system you have and verify that voltage to the fuel level sensor is present at the fuel pump wiring harness. Replace the oxygen sensor that is downstream from the catalytic converter on the side of the engine that does not contain cylinder #1. Also, if a oxygen sensor code stating "heater circuit malfunction" the sensor has most probably failed. Use the DVOM to test resistance and continuity on all system circuits if actuator and sensor resistance levels are in compliance with manufacturer's specifications.

Process Tips

Diagnostic trouble code B19A7 Gmc Yukon is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B19A7 Gmc Yukon.

Fortunately, B19A7 Gmc Yukon is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.