B15C4 Tata Aria Diagnostic Trouble Code

B15C4 Tata Aria code definition:
B15C4 is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Tata Aria.

B15C4 Tata Aria is described as Fuel System Too Rich, which basically means bank 1's oxygen sensor has detected a rich condition of fuel. This means there's not enough oxygen in the exhaust from too much fuel being delivered into the air and gas mixture for combusion. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a B15C4 Tata Aria diagnostic trouble code may include:

Rich or lean exhaust
Fuel pressure too low
Engine surge
Reduction in engine performance, especially at low RPM levels

Possible Causes :

A faulty oxygen sensor. This will set a code in itself, however, a faulty oxygen sensor does not automatically condemn the sensor. The code just means that the sensor signal was not within specifications. An air leak or any of the above will cause an erroneous signal. There is a multitude of O2 codes relating to O2 performance which gives a clue to the problematic area.
Some aftermarket accessories and performance modifications
Faulty IMRC actuator relay (if equipped)

Common Misdiagnoses

IC Circuit High Voltage Problem
Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
PCM Stack Overrun Problem

Repair Processes :

Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. If the scan tool has that capability, and the scan tool can operate the IMRC valves, then the problem is either resolved and a simple code clearing is all that's left or a new PCM would be called for. Replace the oxygen sensor that is downstream from the catalytic converter on the side of the engine that does not contain cylinder #1. Also, if a oxygen sensor code stating "heater circuit malfunction" the sensor has most probably failed.

Process Tips

Diagnostic trouble code B15C4 Tata Aria is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B15C4 Tata Aria.

Fortunately, B15C4 Tata Aria is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.