B147A Mercury Mountaineer Diagnostic Trouble Code

B147A Mercury Mountaineer code definition:
B147A is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Mercury Mountaineer.

B147A Mercury Mountaineer or the Evaporative Emission Control System Incorrect Purge Flow is the set whenever the computer sees that there is a problem with the flow coming from the purge valve or the purge flow is not enough within the EVAP system. Any code that causes the vehicle's engine to die while running should be fixed as soon as possible, as it can be dangerous for both the vehicle and the passengers of the vehicle.

Symptoms

Symptoms of a B147A Mercury Mountaineer diagnostic trouble code may include:

If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
Corroded or damaged connector
Reduction in engine performance, especially at low RPM levels
Malfunction Indicator Lamp (MIL) illuminated

Possible Causes :

Fuel with a large percentage of sulfur will clog the DPF quickly
The Mass Airflow sensor will also cause this problem. Mass Airflow circuit malfunction.
Dirty air cleaner element Damaged DPF

Common Misdiagnoses

IC Circuit High Voltage Problem
Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
PCM Stack Overrun Problem

Repair Processes :

Find out what kind of system you have and verify that voltage to the fuel level sensor is present at the fuel pump wiring harness. Look at the plug wires to make sure they are not burnt or laying on the exhaust. Check to make sure they are not burnt or corroded. If in doubt, get some Electrical Contact cleaner at any parts store if cleaning of the terminals is needed.

Process Tips

Diagnostic trouble code B147A Mercury Mountaineer is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B147A Mercury Mountaineer.

Fortunately, B147A Mercury Mountaineer is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.