B1380 Paterson Sedan Diagnostic Trouble Code

B1380 Paterson Sedan code definition:
B1380 is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Paterson Sedan.

B1380 Paterson Sedan is triggered when the bank 1 camshaft position sensor doesn't match the signal from the crankshaft position sensor. Other symptoms that may indicate this problem are when the Check Engine Light illuminates and when there is a visible lack of engine power.

Symptoms

Symptoms of a B1380 Paterson Sedan diagnostic trouble code may include:

Fuel pressure too low
Rich or lean exhaust
Diminished fuel efficiency
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected

Possible Causes :

A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
Faulty IMRC actuator relay (if equipped)
Faulty IMRC actuator/sensor

Common Misdiagnoses

TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem
Problem

Repair Processes :

Pack the connector cavity with dielectric silicone compound (same stuff they use for light bulb sockets and spark plug wires) and reassemble. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground.

Process Tips

Diagnostic trouble code B1380 Paterson Sedan is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B1380 Paterson Sedan.

Fortunately, B1380 Paterson Sedan is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.