B1081 Jeep Commander Diagnostic Trouble Code

B1081 Jeep Commander code definition:
B1081 is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Jeep Commander.

B1081 Jeep Commander shows up when there's an electrical problem that causes the fuel volume regulator to malfunction and open. It's quite an unusual problem and likely intermittent. So if the problem persists despite of your diagnosis, then you should never hesitate to take your vehicle to your dealer or to a qualified mechanic.

Symptoms

Symptoms of a B1081 Jeep Commander diagnostic trouble code may include:

Fuel pressure too low
Rich or lean exhaust
Diminished fuel efficiency
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.

Possible Causes :

An air leak forward of the DPF will change the sensor readings resulting in the code
Rusty exhaust systems, cracked exhaust manifolds or damaged or missing gaskets or donuts will cause air leaks.
Faulty IMRC actuator/sensor

Common Misdiagnoses

Crankshaft Position Sensor Circuit Performance Problem
TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
Kick-Down Switch Failed Short Problem

Repair Processes :

You might continue by connecting the scanner to the vehicle diagnostic connector and retrieving all stored codes and freeze frame data. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Look at the plug wires to make sure they are not burnt or laying on the exhaust.

Process Tips

Diagnostic trouble code B1081 Jeep Commander is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B1081 Jeep Commander.

Fortunately, B1081 Jeep Commander is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.