B107D Batten 3.6 Diagnostic Trouble Code

B107D Batten 3.6 code definition:
B107D is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Batten 3.6.

B107D Batten 3.6 is triggered when the bank 1 camshaft position sensor doesn't match the signal from the crankshaft position sensor. As you drive and when specific conditions are slowly met, the vapors will gradually purge from the charcoal canister and will get burned within your engine.

Symptoms

Symptoms of a B107D Batten 3.6 diagnostic trouble code may include:

Rich or lean exhaust
Fuel pressure too low
Engine surge
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.

Possible Causes :

Rough running engine due to misfiring plugs. Many engines have misfire codes to indicate the cylinder effected, such as P0307 for number 7.
Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)
Faulty IMRC actuator relay (if equipped)

Common Misdiagnoses

Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
Kick-Down Switch Failed Short Problem
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit Problem

Repair Processes :

Look at the plug wires to make sure they are not burnt or laying on the exhaust. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Use the DVOM to test resistance and continuity on all system circuits if actuator and sensor resistance levels are in compliance with manufacturer's specifications.

Process Tips

Diagnostic trouble code B107D Batten 3.6 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B107D Batten 3.6.

Fortunately, B107D Batten 3.6 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.