B1035 Adler 55 Diagnostic Trouble Code

B1035 Adler 55 code definition:
B1035 is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Adler 55.

B1035 Adler 55 is defined as Ignition Coil B Primary/Secondary Circuit Malfunction.This code is a generic trouble code, meaning it applies to all vehicles equipped with OBD-II tool, or vehicles made since 1996 up to present. The spark should have a light tan color. If the sensor probe comes with white and chalky parts, this means it has been lagging between switching phases, and should be replaced.

Symptoms

Symptoms of a B1035 Adler 55 diagnostic trouble code may include:

Poor acceleration
Cherry red hot catalytic converter
Possible spark knock (detonation / pre-ignition)
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.

Possible Causes :

An air leak forward of the DPF will change the sensor readings resulting in the code
Rusty exhaust systems, cracked exhaust manifolds or damaged or missing gaskets or donuts will cause air leaks.
A large air leak at or near the number one oxygen sensor would also cause a lean mixture.

Common Misdiagnoses

Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
Kick-Down Switch Failed Short Problem
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit Problem

Repair Processes :

If all testing has passed so far yet you still have the same code, check your scan tool and see if it can open and close the IMRC valve. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector.

Process Tips

Diagnostic trouble code B1035 Adler 55 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B1035 Adler 55.

Fortunately, B1035 Adler 55 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.