B1014 Ogle 1.5 Diagnostic Trouble Code

B1014 Ogle 1.5 code definition:
B1014 is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Ogle 1.5.

B1014 Ogle 1.5 is described as Oxygen Sensor Circuit No Activity Detected Bank 2 Sensor 1. This code appears when the PCM (powertrain control module, also known as ECM or engine control module in other brands) remains at or close the 0.450 set voltage point. Other serious codes may cause this code to pop up, and they may come with dangerous drivability issues that may expose you to safety risks and cause damage to the engine in the long run.

Symptoms

Symptoms of a B1014 Ogle 1.5 diagnostic trouble code may include:

Fuel pressure too low
Rich or lean exhaust
Diminished fuel efficiency
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.

Possible Causes :

Rough running engine due to misfiring plugs. Many engines have misfire codes to indicate the cylinder effected, such as P0307 for number 7.
Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)
Faulty IMRC actuator/sensor

Common Misdiagnoses

IC Circuit High Voltage Problem
Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
PCM Stack Overrun Problem

Repair Processes :

Look at the plug wires to make sure they are not burnt or laying on the exhaust. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors. Pull the connectors apart and carefully look at the terminals (the metal parts) inside the connectors.

Process Tips

Diagnostic trouble code B1014 Ogle 1.5 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B1014 Ogle 1.5.

Fortunately, B1014 Ogle 1.5 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.