B0145 Buick Blackhawk Diagnostic Trouble Code

B0145 Buick Blackhawk code definition:
B0145 is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Buick Blackhawk.

B0145 Buick Blackhawk is defined as Knock Sensor Circuit Range Performance (Bank 1 or Single Sensor). This refers to camshaft timing, which in this case is over-retarded. Other serious codes may cause this code to pop up, and they may come with dangerous drivability issues that may expose you to safety risks and cause damage to the engine in the long run.

Symptoms

Symptoms of a B0145 Buick Blackhawk diagnostic trouble code may include:
  • Rich or lean exhaust
  • Fuel pressure too low
  • Engine surge
  • If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
Place of B0145 in engine

Possible Causes :

  • A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
  • Faulty IMRC actuator relay (if equipped)
  • Faulty IMRC actuator/sensor

Common Misdiagnoses

  1. IC Circuit High Voltage Problem
  2. Control Module Throttle Actuator Position Performance Problem
  3. Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
  4. Cruise Vehicle Speed/Set Speed Difference Too High Problem
  5. PCM Stack Overrun Problem

Repair Processes :

Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors. Pull the connectors apart and carefully look at the terminals (the metal parts) inside the connectors. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Oxygen sensors signal the engine management computer the amount of oxygen present in the exhaust, which is used in determining and controlling the fuel ratio.

Process Tips

Diagnostic trouble code B0145 Buick Blackhawk is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B0145 Buick Blackhawk.

Fortunately, B0145 Buick Blackhawk is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

Diagnostic Trouble Code look-up and check engine light code viewer.

About Us | Contact | Privacy

Copyright 2022 - https://DiagnosticTrouble.com

Small Logo