B0104 Vauxhall Viscount Diagnostic Trouble Code

B0104 Vauxhall Viscount code definition:
B0104 is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Vauxhall Viscount.

B0104 Vauxhall Viscount is described as Oxygen Sensor Circuit No Activity Detected Bank 2 Sensor 1. This code appears when the PCM (powertrain control module, also known as ECM or engine control module in other brands) remains at or close the 0.450 set voltage point. The PCM then uses this data to provide the right strategies for the fuel delivery and ignition timing of the engine.

Symptoms

Symptoms of a B0104 Vauxhall Viscount diagnostic trouble code may include:
  • The engine oil will exhibit dilution from the ECUs attempts to increase engine temperature. Some vehicles advance the fuel injection timing slightly after top center to afterburn a small amount of fuel to increase exhaust temperatures. Some of this fuel enters the crankcase. When the ECU determines the necessity to regenerate the DPF, the service life of the oil be shortened significantly
  • Faulty or damaged wiring
  • Hesitation upon acceleration
  • Engine surge
Place of B0104 in engine

Possible Causes :

  • Some aftermarket accessories and performance modifications
  • A faulty oxygen sensor. This will set a code in itself, however, a faulty oxygen sensor does not automatically condemn the sensor. The code just means that the sensor signal was not within specifications. An air leak or any of the above will cause an erroneous signal. There is a multitude of O2 codes relating to O2 performance which gives a clue to the problematic area.
  • Defective ECU strategies or components will prevent proper regeneration

Common Misdiagnoses

  1. TP Sensor Learn Not Complete Problem
  2. Low Coolant Circuit Problem
  3. Cruise Control System - Vehicle Accel Too High Problem
  4. TFP Valve Position Switch-Drive Without Drive Ratio Problem
  5. Problem

Repair Processes :

With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Pack the connector cavity with dielectric silicone compound (same stuff they use for light bulb sockets and spark plug wires) and reassemble.

Process Tips

Diagnostic trouble code B0104 Vauxhall Viscount is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B0104 Vauxhall Viscount.

Fortunately, B0104 Vauxhall Viscount is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

Diagnostic Trouble Code look-up and check engine light code viewer.

Copyright 2019 - https://diagnosticTrouble.com

Small Logo