B00E7 Diagnostic Trouble Code


B00E7 is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code.

It is considered generic because it applies to all makes and models of vehicles, although specific repair steps may be different depending on your car model.

Symptoms

Symptoms of a B00E7 diagnostic trouble code may include:
  • The engine oil will exhibit dilution from the ECUs attempts to increase engine temperature. Some vehicles advance the fuel injection timing slightly after top center to afterburn a small amount of fuel to increase exhaust temperatures. Some of this fuel enters the crankcase. When the ECU determines the necessity to regenerate the DPF, the service life of the oil be shortened significantly
  • Faulty or damaged wiring
  • Hesitation upon acceleration
  • Reduction in engine performance, especially at low RPM levels
Place of B00E7 in engine

Possible Causes :

  • A faulty oxygen sensor. This will set a code in itself, however, a faulty oxygen sensor does not automatically condemn the sensor. The code just means that the sensor signal was not within specifications. An air leak or any of the above will cause an erroneous signal. There is a multitude of O2 codes relating to O2 performance which gives a clue to the problematic area.
  • Some aftermarket accessories and performance modifications
  • Defective ECU strategies or components will prevent proper regeneration

Repair Processes :

Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Pack the connector cavity with dielectric silicone compound (same stuff they use for light bulb sockets and spark plug wires) and reassemble. If the engine displays a miss and there wasn't a code, determine which cylinder is misfiring. If the exhaust manifold is visible, spay or pour a small amount of water on each cylinder exhaust port. Water will evaporate immediately on good cylinders and slowly on the missing cylinder. If this can't be accomplished pull the plugs and check the condition.

Process Tips

Diagnostic trouble code B00E7 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B00E7.

Fortunately, B00E7 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

P1205 Trouble Code For Specific Cars

Diagnostic Trouble Code look-up and check engine light code viewer.

Copyright 2019 - https://diagnosticTrouble.com

Small Logo