B00E5 Ford Contour Diagnostic Trouble Code

B00E5 Ford Contour code definition:
B00E5 is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Ford Contour.

B00E5 Ford Contour is defined as Camshaft Position Sensor A Circuit Low. This means the CMP (camshaft position) sensor circuit on engine bank 1 sends an irregular reading. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a B00E5 Ford Contour diagnostic trouble code may include:
  • Corroded or damaged connector
  • If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
  • Lack of power
  • Engine surge
Place of B00E5 in engine

Possible Causes :

  • Rusty exhaust systems, cracked exhaust manifolds or damaged or missing gaskets or donuts will cause air leaks.
  • An air leak forward of the DPF will change the sensor readings resulting in the code
  • Rough running engine due to misfiring plugs. Many engines have misfire codes to indicate the cylinder effected, such as P0307 for number 7.

Common Misdiagnoses

  1. Exhaust Gas Recirculation System Valve 1 Problem
  2. BBV Sensor Circuit Low Voltage Problem
  3. Transmission Engaged At High Throttle Angle Problem
  4. Cruise Inhibit Control Circuit Problem
  5. TFP Valve Position Switch-Drive Without Drive Ratio Problem

Repair Processes :

If all testing has passed so far yet you still have the same code, check your scan tool and see if it can open and close the IMRC valve. Find out what kind of system you have and verify that voltage to the fuel level sensor is present at the fuel pump wiring harness.

Process Tips

Diagnostic trouble code B00E5 Ford Contour is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B00E5 Ford Contour.

Fortunately, B00E5 Ford Contour is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

Diagnostic Trouble Code look-up and check engine light code viewer.

Copyright 2020 - https://diagnosticTrouble.com

Small Logo