B0071 Standard Ten Diagnostic Trouble Code

B0071 Standard Ten code definition:
B0071 is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Standard Ten.

B0071 Standard Ten is described as Fuel System Too Rich, which basically means bank 1's oxygen sensor has detected a rich condition of fuel. This means there's not enough oxygen in the exhaust from too much fuel being delivered into the air and gas mixture for combusion. Other serious codes may cause this code to pop up, and they may come with dangerous drivability issues that may expose you to safety risks and cause damage to the engine in the long run.

Symptoms

Symptoms of a B0071 Standard Ten diagnostic trouble code may include:
  • The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.
  • Faulty PCM
  • If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
  • Rich or lean exhaust
Place of B0071 in engine

Possible Causes :

  • Faulty IMRC actuator relay (if equipped)
  • A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
  • An air leak forward of the DPF will change the sensor readings resulting in the code

Common Misdiagnoses

  1. Control Module Throttle Actuator Position Performance Problem
  2. Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
  3. Cruise Vehicle Speed/Set Speed Difference Too High Problem
  4. Kick-Down Switch Failed Short Problem
  5. Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit Problem

Repair Processes :

It should be pretty close to battery voltage (12 volts). If not, then this is the circuit that has the problem. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector.

Process Tips

Diagnostic trouble code B0071 Standard Ten is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B0071 Standard Ten.

Fortunately, B0071 Standard Ten is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

Diagnostic Trouble Code look-up and check engine light code viewer.

Copyright 2020 - https://diagnosticTrouble.com

Small Logo