U20E7 Adler 12 Diagnostic Trouble Code

U20E7 Adler 12 code definition:
U20E7 is a kind of OBD-II Diagnostic U-Network Diagnostic Trouble Code for Adler 12.

U20E7 Adler 12 is described as Oxygen Sensor Circuit No Activity Detected Bank 2 Sensor 1. This code appears when the PCM (powertrain control module, also known as ECM or engine control module in other brands) remains at or close the 0.450 set voltage point. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a U20E7 Adler 12 diagnostic trouble code may include:
Place of U20E7 in engine

Possible Causes :

  • Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.
  • Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.
  • Rough running engine due to misfiring plugs. Many engines have misfire codes to indicate the cylinder effected, such as P0307 for number 7.

Common Misdiagnoses

  1. Control Module Throttle Actuator Position Performance Problem
  2. Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
  3. Cruise Vehicle Speed/Set Speed Difference Too High Problem
  4. Kick-Down Switch Failed Short Problem
  5. Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit Problem

Repair Processes :

Look for damage to the tank indicating impact that may have damaged the fuel pump or sender. Look at the plug wires to make sure they are not burnt or laying on the exhaust. Once located, visually inspect the connectors and wiring. Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors.

Process Tips

Diagnostic trouble code U20E7 Adler 12 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before U20E7 Adler 12.

Fortunately, U20E7 Adler 12 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

Diagnostic Trouble Code look-up and check engine light code viewer.

About Us | Contact | Privacy

Copyright 2024 - https://DiagnosticTrouble.com

Small Logo