U207A Nsu Wankel Diagnostic Trouble Code

U207A Nsu Wankel code definition:
U207A is a kind of OBD-II Diagnostic U-Network Diagnostic Trouble Code for Nsu Wankel.

U207A Nsu Wankel shows up when there's an electrical problem that causes the fuel volume regulator to malfunction and open. It's quite an unusual problem and likely intermittent. As you drive and when specific conditions are slowly met, the vapors will gradually purge from the charcoal canister and will get burned within your engine.

Symptoms

Symptoms of a U207A Nsu Wankel diagnostic trouble code may include:
Place of U207A in engine

Possible Causes :

  • Faulty IMRC actuator relay (if equipped)
  • A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
  • An air leak forward of the DPF will change the sensor readings resulting in the code

Common Misdiagnoses

  1. Exhaust Gas Recirculation System Valve 1 Problem
  2. BBV Sensor Circuit Low Voltage Problem
  3. Transmission Engaged At High Throttle Angle Problem
  4. Cruise Inhibit Control Circuit Problem
  5. TFP Valve Position Switch-Drive Without Drive Ratio Problem

Repair Processes :

If the scan tool has that capability, and the scan tool can operate the IMRC valves, then the problem is either resolved and a simple code clearing is all that's left or a new PCM would be called for. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Replace the oxygen sensor that is downstream from the catalytic converter on the side of the engine that does not contain cylinder #1. Also, if a oxygen sensor code stating "heater circuit malfunction" the sensor has most probably failed.

Process Tips

Diagnostic trouble code U207A Nsu Wankel is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before U207A Nsu Wankel.

Fortunately, U207A Nsu Wankel is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

Diagnostic Trouble Code look-up and check engine light code viewer.

About Us | Contact | Privacy

Copyright 2024 - https://DiagnosticTrouble.com

Small Logo