U029E Daihatsu Micros Diagnostic Trouble Code

U029E Daihatsu Micros code definition:
U029E is a kind of OBD-II Diagnostic U-Network Diagnostic Trouble Code for Daihatsu Micros.

U029E Daihatsu Micros is defined as Knock Sensor Circuit Range Performance (Bank 1 or Single Sensor). This refers to camshaft timing, which in this case is over-retarded. This is because the barometric pressure sensor is part of the MAF sensor. Sometimes, the MAF's sensing wire can accumulate and get covered with dirt, dust and/or oil residue, which can also lead to the error code.

Symptoms

Symptoms of a U029E Daihatsu Micros diagnostic trouble code may include:

Poor acceleration
Cherry red hot catalytic converter
Possible spark knock (detonation / pre-ignition)
Rich or lean exhaust

Possible Causes :

Faulty IMRC actuator relay (if equipped)
A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
A plugged converter will cause of host of driveability problems as well as set this code. A severely plugged converter will result in the inability to increase rpm when under load. Look for a code such as P0421 -- catalytic converter efficiency below threshold if the converter indicating a faulty converter.

Common Misdiagnoses

TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem
Problem

Repair Processes :

Check to make sure they are not burnt or corroded. If in doubt, get some Electrical Contact cleaner at any parts store if cleaning of the terminals is needed. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Oxygen sensors signal the engine management computer the amount of oxygen present in the exhaust, which is used in determining and controlling the fuel ratio.

Process Tips

Diagnostic trouble code U029E Daihatsu Micros is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before U029E Daihatsu Micros.

Fortunately, U029E Daihatsu Micros is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.