U0220 Standard Ensign Diagnostic Trouble Code

U0220 Standard Ensign code definition:
U0220 is a kind of OBD-II Diagnostic U-Network Diagnostic Trouble Code for Standard Ensign.

U0220 Standard Ensign is defined as Cylinder 3 Injector Circuit Malfunction. This code means the PCM (powertrain control module, also known as ECM or engine control) has detected a problem in the injector or its wiring, or in injector circuit for cylinder 3. If the car doesn't start, they will proceed by testing the voltage at the fuel pump connector and see if the fuel pump relay, fuse, and PCM circuitry should be inspected.

Symptoms

Symptoms of a U0220 Standard Ensign diagnostic trouble code may include:
Place of U0220 in engine

Possible Causes :

  • A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
  • Faulty IMRC actuator relay (if equipped)
  • Dirty air cleaner element Damaged DPF

Common Misdiagnoses

  1. Vehicle Speed Output Circuit Problem
  2. Cruise Control Servo Indicates Low Problem
  3. A/C System High Pressure High Temperature Problem
  4. PCM Stack Overrun Problem
  5. Transmission Control Module Reprogrammable Memory Problem

Repair Processes :

Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors. Pull the connectors apart and carefully look at the terminals (the metal parts) inside the connectors. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Replace the oxygen sensor that is downstream from the catalytic converter on the side of the engine that does not contain cylinder #1. Also, if a oxygen sensor code stating "heater circuit malfunction" the sensor has most probably failed.

Process Tips

Diagnostic trouble code U0220 Standard Ensign is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before U0220 Standard Ensign.

Fortunately, U0220 Standard Ensign is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

Diagnostic Trouble Code look-up and check engine light code viewer.

About Us | Contact | Privacy

Copyright 2024 - https://DiagnosticTrouble.com

Small Logo