U0218 Giannini 1000 Diagnostic Trouble Code

U0218 Giannini 1000 code definition:
U0218 is a kind of OBD-II Diagnostic U-Network Diagnostic Trouble Code for Giannini 1000.

U0218 Giannini 1000 is defined as Knock Sensor Circuit Range Performance (Bank 1 or Single Sensor). This refers to camshaft timing, which in this case is over-retarded. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a U0218 Giannini 1000 diagnostic trouble code may include:
Place of U0218 in engine

Possible Causes :

  • The Mass Airflow sensor is a hot wire that senses the volume of air entering the intake manifold. The computer uses this information to control fuel mixture.
  • Defective ECU strategies or components will prevent proper regeneration
  • A large vacuum leak would cause a massive amount of un-metered air to enter the intake manifold resulting in an overly lean mixture.

Common Misdiagnoses

  1. IC Circuit High Voltage Problem
  2. Control Module Throttle Actuator Position Performance Problem
  3. Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
  4. Cruise Vehicle Speed/Set Speed Difference Too High Problem
  5. PCM Stack Overrun Problem

Repair Processes :

Look at the plug wires to make sure they are not burnt or laying on the exhaust. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Pack the connector cavity with dielectric silicone compound (same stuff they use for light bulb sockets and spark plug wires) and reassemble.

Process Tips

Diagnostic trouble code U0218 Giannini 1000 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before U0218 Giannini 1000.

Fortunately, U0218 Giannini 1000 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

Diagnostic Trouble Code look-up and check engine light code viewer.

About Us | Contact | Privacy

Copyright 2024 - https://DiagnosticTrouble.com

Small Logo