U0148 Oldsmobile Custom Diagnostic Trouble Code

U0148 Oldsmobile Custom code definition:
U0148 is a kind of OBD-II Diagnostic U-Network Diagnostic Trouble Code for Oldsmobile Custom.

U0148 Oldsmobile Custom is defined as Camshaft Position Sensor A Circuit Low. This means the CMP (camshaft position) sensor circuit on engine bank 1 sends an irregular reading. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a U0148 Oldsmobile Custom diagnostic trouble code may include:
Place of U0148 in engine

Possible Causes :

  • An air leak forward of the DPF will change the sensor readings resulting in the code
  • Rusty exhaust systems, cracked exhaust manifolds or damaged or missing gaskets or donuts will cause air leaks.
  • Rough running engine due to misfiring plugs. Many engines have misfire codes to indicate the cylinder effected, such as P0307 for number 7.

Common Misdiagnoses

  1. IC Circuit High Voltage Problem
  2. Control Module Throttle Actuator Position Performance Problem
  3. Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
  4. Cruise Vehicle Speed/Set Speed Difference Too High Problem
  5. PCM Stack Overrun Problem

Repair Processes :

Pack the connector cavity with dielectric silicone compound (same stuff they use for light bulb sockets and spark plug wires) and reassemble. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. If the engine displays a miss and there wasn't a code, determine which cylinder is misfiring. If the exhaust manifold is visible, spay or pour a small amount of water on each cylinder exhaust port. Water will evaporate immediately on good cylinders and slowly on the missing cylinder. If this can't be accomplished pull the plugs and check the condition.

Process Tips

Diagnostic trouble code U0148 Oldsmobile Custom is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before U0148 Oldsmobile Custom.

Fortunately, U0148 Oldsmobile Custom is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

Diagnostic Trouble Code look-up and check engine light code viewer.

About Us | Contact | Privacy

Copyright 2024 - https://DiagnosticTrouble.com

Small Logo