U0118 Sunbeam Rapier Diagnostic Trouble Code

U0118 Sunbeam Rapier code definition:
U0118 is a kind of OBD-II Diagnostic U-Network Diagnostic Trouble Code for Sunbeam Rapier.

U0118 Sunbeam Rapier is described as Oxygen Sensor Circuit No Activity Detected Bank 2 Sensor 1. This code appears when the PCM (powertrain control module, also known as ECM or engine control module in other brands) remains at or close the 0.450 set voltage point. This is because the barometric pressure sensor is part of the MAF sensor. Sometimes, the MAF's sensing wire can accumulate and get covered with dirt, dust and/or oil residue, which can also lead to the error code.

Symptoms

Symptoms of a U0118 Sunbeam Rapier diagnostic trouble code may include:

If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
Corroded or damaged connector
Reduction in engine performance, especially at low RPM levels
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.

Possible Causes :

Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.
Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.
Fuel with a large percentage of sulfur will clog the DPF quickly

Common Misdiagnoses

Vehicle Speed Output Circuit Problem
Cruise Control Servo Indicates Low Problem
A/C System High Pressure High Temperature Problem
PCM Stack Overrun Problem
Transmission Control Module Reprogrammable Memory Problem

Repair Processes :

Look for damage to the tank indicating impact that may have damaged the fuel pump or sender. If all testing has passed so far yet you still have the same code, check your scan tool and see if it can open and close the IMRC valve.

Process Tips

Diagnostic trouble code U0118 Sunbeam Rapier is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before U0118 Sunbeam Rapier.

Fortunately, U0118 Sunbeam Rapier is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.