P2939 Toyota Will Diagnostic Trouble Code

P2939 Toyota Will code definition:
P2939 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Toyota Will.

P2939 Toyota Will is described as Oxygen Sensor Circuit No Activity Detected (Bank 1, Sensor 1). This means there's a problem in the front oxygen sensor on Bank 1, as the O2 sensor is inactive. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a P2939 Toyota Will diagnostic trouble code may include:

Engine surge
Blown fuse (if applicable)
Lack of power
Hesitation upon acceleration

Possible Causes :

Some aftermarket accessories and performance modifications
A faulty oxygen sensor. This will set a code in itself, however, a faulty oxygen sensor does not automatically condemn the sensor. The code just means that the sensor signal was not within specifications. An air leak or any of the above will cause an erroneous signal. There is a multitude of O2 codes relating to O2 performance which gives a clue to the problematic area.
Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)

Common Misdiagnoses

IC Circuit High Voltage Problem
Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
PCM Stack Overrun Problem

Repair Processes :

With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. If all testing has passed so far yet you still have the same code, check your scan tool and see if it can open and close the IMRC valve.

Process Tips

Diagnostic trouble code P2939 Toyota Will is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P2939 Toyota Will.

Fortunately, P2939 Toyota Will is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.