P2909 Volkswagen K70 Diagnostic Trouble Code

P2909 Volkswagen K70 code definition:
P2909 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Volkswagen K70.

P2909 Volkswagen K70 is defined as Camshaft Position Sensor A Circuit Low. This means the CMP (camshaft position) sensor circuit on engine bank 1 sends an irregular reading. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a P2909 Volkswagen K70 diagnostic trouble code may include:

Poor acceleration
Cherry red hot catalytic converter
Possible spark knock (detonation / pre-ignition)
Diminished fuel efficiency

Possible Causes :

The Mass Airflow sensor is a hot wire that senses the volume of air entering the intake manifold. The computer uses this information to control fuel mixture.
Defective ECU strategies or components will prevent proper regeneration
A large air leak at or near the number one oxygen sensor would also cause a lean mixture.

Common Misdiagnoses

IC Circuit High Voltage Problem
Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
PCM Stack Overrun Problem

Repair Processes :

Look at the plug wires to make sure they are not burnt or laying on the exhaust. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. It should be pretty close to battery voltage (12 volts). If not, then this is the circuit that has the problem.

Process Tips

Diagnostic trouble code P2909 Volkswagen K70 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P2909 Volkswagen K70.

Fortunately, P2909 Volkswagen K70 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.