P2885 Rover T.3 Diagnostic Trouble Code

P2885 Rover T.3 code definition:
P2885 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Rover T.3.

P2885 Rover T.3 or the Evaporative Emission Control System Incorrect Purge Flow is the set whenever the computer sees that there is a problem with the flow coming from the purge valve or the purge flow is not enough within the EVAP system. Other serious codes may cause this code to pop up, and they may come with dangerous drivability issues that may expose you to safety risks and cause damage to the engine in the long run.

Symptoms

Symptoms of a P2885 Rover T.3 diagnostic trouble code may include:

Vacuum leak on the engine
Reduction in engine performance, especially at low RPM levels
Engine surge
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected

Possible Causes :

Fuel with a large percentage of sulfur will clog the DPF quickly
The Mass Airflow sensor will also cause this problem. Mass Airflow circuit malfunction.
Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)

Common Misdiagnoses

Exhaust Gas Recirculation System Valve 1 Problem
BBV Sensor Circuit Low Voltage Problem
Transmission Engaged At High Throttle Angle Problem
Cruise Inhibit Control Circuit Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem

Repair Processes :

Look for damage to the tank indicating impact that may have damaged the fuel pump or sender. Look at the plug wires to make sure they are not burnt or laying on the exhaust. Check to make sure they are not burnt or corroded. If in doubt, get some Electrical Contact cleaner at any parts store if cleaning of the terminals is needed.

Process Tips

Diagnostic trouble code P2885 Rover T.3 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P2885 Rover T.3.

Fortunately, P2885 Rover T.3 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.