P279A Subaru H6 Diagnostic Trouble Code

P279A Subaru H6 code definition:
P279A is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Subaru H6.

P279A Subaru H6 is defined as Ignition Coil B Primary/Secondary Circuit Malfunction.This code is a generic trouble code, meaning it applies to all vehicles equipped with OBD-II tool, or vehicles made since 1996 up to present. The PCM then uses this data to provide the right strategies for the fuel delivery and ignition timing of the engine.

Symptoms

Symptoms of a P279A Subaru H6 diagnostic trouble code may include:

Faulty PCM
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.
Poor acceleration
Hesitation upon acceleration

Possible Causes :

Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.
Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.
A large air leak at or near the number one oxygen sensor would also cause a lean mixture.

Common Misdiagnoses

TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem
Problem

Repair Processes :

Find out what kind of system you have and verify that voltage to the fuel level sensor is present at the fuel pump wiring harness. Replace the oxygen sensor that is downstream from the catalytic converter on the side of the engine that does not contain cylinder #1. Also, if a oxygen sensor code stating "heater circuit malfunction" the sensor has most probably failed. It should be pretty close to battery voltage (12 volts). If not, then this is the circuit that has the problem.

Process Tips

Diagnostic trouble code P279A Subaru H6 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P279A Subaru H6.

Fortunately, P279A Subaru H6 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.