P209E Honda Sm-x Diagnostic Trouble Code

P209E Honda Sm-x code definition:
P209E is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Honda Sm-x.

P209E Honda Sm-x is triggered when the bank 1 camshaft position sensor doesn't match the signal from the crankshaft position sensor. The PCM then uses this data to provide the right strategies for the fuel delivery and ignition timing of the engine.

Symptoms

Symptoms of a P209E Honda Sm-x diagnostic trouble code may include:

Engine surge
Blown fuse (if applicable)
Lack of power
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected

Possible Causes :

A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
Faulty IMRC actuator relay (if equipped)
Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)

Common Misdiagnoses

Vehicle Speed Output Circuit Problem
Cruise Control Servo Indicates Low Problem
A/C System High Pressure High Temperature Problem
PCM Stack Overrun Problem
Transmission Control Module Reprogrammable Memory Problem

Repair Processes :

Once located, visually inspect the connectors and wiring. Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. If the engine displays a miss and there wasn't a code, determine which cylinder is misfiring. If the exhaust manifold is visible, spay or pour a small amount of water on each cylinder exhaust port. Water will evaporate immediately on good cylinders and slowly on the missing cylinder. If this can't be accomplished pull the plugs and check the condition.

Process Tips

Diagnostic trouble code P209E Honda Sm-x is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P209E Honda Sm-x.

Fortunately, P209E Honda Sm-x is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.