P128A Bmw M3 Diagnostic Trouble Code

P128A Bmw M3 code definition:
P128A is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Bmw M3.

P128A Bmw M3 is defined as Knock Sensor Circuit Range Performance (Bank 1 or Single Sensor). This refers to camshaft timing, which in this case is over-retarded. Other serious codes may cause this code to pop up, and they may come with dangerous drivability issues that may expose you to safety risks and cause damage to the engine in the long run.

Symptoms

Symptoms of a P128A Bmw M3 diagnostic trouble code may include:

Lack of power
Faulty O2 Sensor
Poor acceleration
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.

Possible Causes :

An air leak forward of the DPF will change the sensor readings resulting in the code
Rusty exhaust systems, cracked exhaust manifolds or damaged or missing gaskets or donuts will cause air leaks.
Rough running engine due to misfiring plugs. Many engines have misfire codes to indicate the cylinder effected, such as P0307 for number 7.

Common Misdiagnoses

Exhaust Gas Recirculation System Valve 1 Problem
BBV Sensor Circuit Low Voltage Problem
Transmission Engaged At High Throttle Angle Problem
Cruise Inhibit Control Circuit Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem

Repair Processes :

Once located, visually inspect the connectors and wiring. Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground.

Process Tips

Diagnostic trouble code P128A Bmw M3 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P128A Bmw M3.

Fortunately, P128A Bmw M3 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.