P020D Bmw M1 Diagnostic Trouble Code

P020D Bmw M1 code definition:
P020D is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Bmw M1.

P020D Bmw M1 is defined as Cylinder 3 Injector Circuit Malfunction. This code means the PCM (powertrain control module, also known as ECM or engine control) has detected a problem in the injector or its wiring, or in injector circuit for cylinder 3. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a P020D Bmw M1 diagnostic trouble code may include:
Place of P020D in engine

Possible Causes :

  • Defective ECU strategies or components will prevent proper regeneration
  • The Mass Airflow sensor is a hot wire that senses the volume of air entering the intake manifold. The computer uses this information to control fuel mixture.
  • Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.

Common Misdiagnoses

  1. IC Circuit High Voltage Problem
  2. Control Module Throttle Actuator Position Performance Problem
  3. Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
  4. Cruise Vehicle Speed/Set Speed Difference Too High Problem
  5. PCM Stack Overrun Problem

Repair Processes :

With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors. Pull the connectors apart and carefully look at the terminals (the metal parts) inside the connectors. Look at the plug wires to make sure they are not burnt or laying on the exhaust.

Process Tips

Diagnostic trouble code P020D Bmw M1 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P020D Bmw M1.

Fortunately, P020D Bmw M1 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

Diagnostic Trouble Code look-up and check engine light code viewer.

About Us | Contact | Privacy

Copyright 2024 - https://DiagnosticTrouble.com

Small Logo