P018C Zender 30-7 Diagnostic Trouble Code

P018C Zender 30-7 code definition:
P018C is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Zender 30-7.

P018C Zender 30-7 is described as Oxygen Sensor Circuit No Activity Detected (Bank 1, Sensor 1). This means there's a problem in the front oxygen sensor on Bank 1, as the O2 sensor is inactive. The PCM then uses this data to provide the right strategies for the fuel delivery and ignition timing of the engine.

Symptoms

Symptoms of a P018C Zender 30-7 diagnostic trouble code may include:
Place of P018C in engine

Possible Causes :

  • A large vacuum leak would cause a massive amount of un-metered air to enter the intake manifold resulting in an overly lean mixture.
  • Faulty IMRC actuator/sensor
  • Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)

Common Misdiagnoses

  1. Vehicle Speed Output Circuit Problem
  2. Cruise Control Servo Indicates Low Problem
  3. A/C System High Pressure High Temperature Problem
  4. PCM Stack Overrun Problem
  5. Transmission Control Module Reprogrammable Memory Problem

Repair Processes :

If the engine displays a miss and there wasn't a code, determine which cylinder is misfiring. If the exhaust manifold is visible, spay or pour a small amount of water on each cylinder exhaust port. Water will evaporate immediately on good cylinders and slowly on the missing cylinder. If this can't be accomplished pull the plugs and check the condition. If all testing has passed so far yet you still have the same code, check your scan tool and see if it can open and close the IMRC valve. Find out what kind of system you have and verify that voltage to the fuel level sensor is present at the fuel pump wiring harness.

Process Tips

Diagnostic trouble code P018C Zender 30-7 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P018C Zender 30-7.

Fortunately, P018C Zender 30-7 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

Diagnostic Trouble Code look-up and check engine light code viewer.

About Us | Contact | Privacy

Copyright 2024 - https://DiagnosticTrouble.com

Small Logo