P017E Gnome 3 Diagnostic Trouble Code

P017E Gnome 3 code definition:
P017E is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Gnome 3.

P017E Gnome 3 is defined as Camshaft Position Sensor A Circuit Low. This means the CMP (camshaft position) sensor circuit on engine bank 1 sends an irregular reading. If the car doesn't start, they will proceed by testing the voltage at the fuel pump connector and see if the fuel pump relay, fuse, and PCM circuitry should be inspected.

Symptoms

Symptoms of a P017E Gnome 3 diagnostic trouble code may include:
Place of P017E in engine

Possible Causes :

  • Some aftermarket accessories and performance modifications
  • A faulty oxygen sensor. This will set a code in itself, however, a faulty oxygen sensor does not automatically condemn the sensor. The code just means that the sensor signal was not within specifications. An air leak or any of the above will cause an erroneous signal. There is a multitude of O2 codes relating to O2 performance which gives a clue to the problematic area.
  • Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)

Common Misdiagnoses

  1. TP Sensor Learn Not Complete Problem
  2. Low Coolant Circuit Problem
  3. Cruise Control System - Vehicle Accel Too High Problem
  4. TFP Valve Position Switch-Drive Without Drive Ratio Problem
  5. Problem

Repair Processes :

With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Once located, visually inspect the connectors and wiring. Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors.

Process Tips

Diagnostic trouble code P017E Gnome 3 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P017E Gnome 3.

Fortunately, P017E Gnome 3 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

Diagnostic Trouble Code look-up and check engine light code viewer.

About Us | Contact | Privacy

Copyright 2024 - https://DiagnosticTrouble.com

Small Logo