P0144 Honda N360 Diagnostic Trouble Code

P0144 Honda N360 code definition:
P0144 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Honda N360.

P0144 Honda N360 is defined as Knock Sensor Circuit Range Performance (Bank 1 or Single Sensor). This refers to camshaft timing, which in this case is over-retarded. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a P0144 Honda N360 diagnostic trouble code may include:

Rich or lean exhaust
Fuel pressure too low
Engine surge
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected

Possible Causes :

A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
Faulty IMRC actuator relay (if equipped)
Faulty IMRC actuator/sensor

Common Misdiagnoses

Exhaust Gas Recirculation System Valve 1 Problem
BBV Sensor Circuit Low Voltage Problem
Transmission Engaged At High Throttle Angle Problem
Cruise Inhibit Control Circuit Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem

Repair Processes :

Pack the connector cavity with dielectric silicone compound (same stuff they use for light bulb sockets and spark plug wires) and reassemble. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Oxygen sensors signal the engine management computer the amount of oxygen present in the exhaust, which is used in determining and controlling the fuel ratio.

Process Tips

Diagnostic trouble code P0144 Honda N360 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P0144 Honda N360.

Fortunately, P0144 Honda N360 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.