P00B6 Ecosse Signature Diagnostic Trouble Code

P00B6 Ecosse Signature code definition:
P00B6 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Ecosse Signature.

P00B6 Ecosse Signature or the Evaporative Emission Control System Incorrect Purge Flow is the set whenever the computer sees that there is a problem with the flow coming from the purge valve or the purge flow is not enough within the EVAP system. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a P00B6 Ecosse Signature diagnostic trouble code may include:
  • The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.
  • Faulty PCM
  • If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
  • Diminished fuel efficiency
Place of P00B6 in engine

Possible Causes :

  • A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
  • Faulty IMRC actuator relay (if equipped)
  • An air leak forward of the DPF will change the sensor readings resulting in the code

Common Misdiagnoses

  1. Exhaust Gas Recirculation System Valve 1 Problem
  2. BBV Sensor Circuit Low Voltage Problem
  3. Transmission Engaged At High Throttle Angle Problem
  4. Cruise Inhibit Control Circuit Problem
  5. TFP Valve Position Switch-Drive Without Drive Ratio Problem

Repair Processes :

Check to make sure they are not burnt or corroded. If in doubt, get some Electrical Contact cleaner at any parts store if cleaning of the terminals is needed. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector.

Process Tips

Diagnostic trouble code P00B6 Ecosse Signature is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P00B6 Ecosse Signature.

Fortunately, P00B6 Ecosse Signature is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

Diagnostic Trouble Code look-up and check engine light code viewer.

Copyright 2021 - https://diagnosticTrouble.com

Small Logo