P0018 Autobianchi Stellina Diagnostic Trouble Code

P0018 Autobianchi Stellina code definition:
P0018 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Autobianchi Stellina.

P0018 Autobianchi Stellina or the Evaporative Emission Control System Incorrect Purge Flow is the set whenever the computer sees that there is a problem with the flow coming from the purge valve or the purge flow is not enough within the EVAP system. If the car doesn't start, they will proceed by testing the voltage at the fuel pump connector and see if the fuel pump relay, fuse, and PCM circuitry should be inspected.

Symptoms

Symptoms of a P0018 Autobianchi Stellina diagnostic trouble code may include:
Place of P0018 in engine

Possible Causes :

  • Faulty IMRC actuator relay (if equipped)
  • A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
  • Faulty IMRC actuator/sensor

Common Misdiagnoses

  1. Crankshaft Position Sensor Circuit Performance Problem
  2. TP Sensor Learn Not Complete Problem
  3. Low Coolant Circuit Problem
  4. Cruise Control System - Vehicle Accel Too High Problem
  5. Kick-Down Switch Failed Short Problem

Repair Processes :

Check to make sure they are not burnt or corroded. If in doubt, get some Electrical Contact cleaner at any parts store if cleaning of the terminals is needed. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Replace the oxygen sensor that is downstream from the catalytic converter on the side of the engine that does not contain cylinder #1. Also, if a oxygen sensor code stating "heater circuit malfunction" the sensor has most probably failed.

Process Tips

Diagnostic trouble code P0018 Autobianchi Stellina is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P0018 Autobianchi Stellina.

Fortunately, P0018 Autobianchi Stellina is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

Diagnostic Trouble Code look-up and check engine light code viewer.

About Us | Contact | Privacy

Copyright 2024 - https://DiagnosticTrouble.com

Small Logo