P0009 Hyundai Concept Diagnostic Trouble Code

P0009 Hyundai Concept code definition:
P0009 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Hyundai Concept.

P0009 Hyundai Concept is described as Fuel Rail Pressure Sensor Circuit Malfunction. This code is strictly about the incoming signal from the FRP (fuel rail pressure) sensor falling below the calibrated limit for a certain period of time. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a P0009 Hyundai Concept diagnostic trouble code may include:

Rich or lean exhaust
Fuel pressure too low
Engine surge
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.

Possible Causes :

An air leak forward of the DPF will change the sensor readings resulting in the code
Rusty exhaust systems, cracked exhaust manifolds or damaged or missing gaskets or donuts will cause air leaks.
Faulty IMRC actuator relay (if equipped)

Common Misdiagnoses

Exhaust Gas Recirculation System Valve 1 Problem
BBV Sensor Circuit Low Voltage Problem
Transmission Engaged At High Throttle Angle Problem
Cruise Inhibit Control Circuit Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem

Repair Processes :

Pack the connector cavity with dielectric silicone compound (same stuff they use for light bulb sockets and spark plug wires) and reassemble. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Look at the plug wires to make sure they are not burnt or laying on the exhaust.

Process Tips

Diagnostic trouble code P0009 Hyundai Concept is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P0009 Hyundai Concept.

Fortunately, P0009 Hyundai Concept is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.