C3694 Sunbeam-talbot Mk Iii Diagnostic Trouble Code

C3694 Sunbeam-talbot Mk Iii code definition:
C3694 is a kind of OBD-II Diagnostic C-Chassis Diagnostic Trouble Code for Sunbeam-talbot Mk Iii.

C3694 Sunbeam-talbot Mk Iii or the Evaporative Emission Control System Incorrect Purge Flow is the set whenever the computer sees that there is a problem with the flow coming from the purge valve or the purge flow is not enough within the EVAP system. If the car doesn't start, they will proceed by testing the voltage at the fuel pump connector and see if the fuel pump relay, fuse, and PCM circuitry should be inspected.

Symptoms

Symptoms of a C3694 Sunbeam-talbot Mk Iii diagnostic trouble code may include:

The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.
Faulty PCM
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
Rich or lean exhaust

Possible Causes :

Faulty IMRC actuator relay (if equipped)
A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
An air leak forward of the DPF will change the sensor readings resulting in the code

Common Misdiagnoses

TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem
Problem

Repair Processes :

Use the DVOM to test resistance and continuity on all system circuits if actuator and sensor resistance levels are in compliance with manufacturer's specifications. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Oxygen sensors signal the engine management computer the amount of oxygen present in the exhaust, which is used in determining and controlling the fuel ratio.

Process Tips

Diagnostic trouble code C3694 Sunbeam-talbot Mk Iii is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before C3694 Sunbeam-talbot Mk Iii.

Fortunately, C3694 Sunbeam-talbot Mk Iii is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.