C0911 Holden Gts Diagnostic Trouble Code

C0911 Holden Gts code definition:
C0911 is a kind of OBD-II Diagnostic C-Chassis Diagnostic Trouble Code for Holden Gts.

C0911 Holden Gts is triggered when the bank 1 camshaft position sensor doesn't match the signal from the crankshaft position sensor. The PCM then uses this data to provide the right strategies for the fuel delivery and ignition timing of the engine.

Symptoms

Symptoms of a C0911 Holden Gts diagnostic trouble code may include:

Hesitation upon acceleration
Excessive exhaust leak
Rich or lean exhaust
Lack of power

Possible Causes :

Faulty IMRC actuator relay (if equipped)
A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
Some aftermarket accessories and performance modifications

Common Misdiagnoses

TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem
Problem

Repair Processes :

It should be pretty close to battery voltage (12 volts). If not, then this is the circuit that has the problem. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. If the engine displays a miss and there wasn't a code, determine which cylinder is misfiring. If the exhaust manifold is visible, spay or pour a small amount of water on each cylinder exhaust port. Water will evaporate immediately on good cylinders and slowly on the missing cylinder. If this can't be accomplished pull the plugs and check the condition.

Process Tips

Diagnostic trouble code C0911 Holden Gts is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before C0911 Holden Gts.

Fortunately, C0911 Holden Gts is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.