C0331 Ford Probe Gt Diagnostic Trouble Code

C0331 Ford Probe Gt code definition:
C0331 is a kind of OBD-II Diagnostic C-Chassis Diagnostic Trouble Code for Ford Probe Gt.

C0331 Ford Probe Gt is defined as Knock Sensor Circuit Range Performance (Bank 1 or Single Sensor). This refers to camshaft timing, which in this case is over-retarded. If the car doesn't start, they will proceed by testing the voltage at the fuel pump connector and see if the fuel pump relay, fuse, and PCM circuitry should be inspected.

Symptoms

Symptoms of a C0331 Ford Probe Gt diagnostic trouble code may include:

Rich or lean exhaust
Fuel pressure too low
Engine surge
Reduction in engine performance, especially at low RPM levels

Possible Causes :

A faulty oxygen sensor. This will set a code in itself, however, a faulty oxygen sensor does not automatically condemn the sensor. The code just means that the sensor signal was not within specifications. An air leak or any of the above will cause an erroneous signal. There is a multitude of O2 codes relating to O2 performance which gives a clue to the problematic area.
Some aftermarket accessories and performance modifications
Faulty IMRC actuator relay (if equipped)

Common Misdiagnoses

Vehicle Speed Output Circuit Problem
Cruise Control Servo Indicates Low Problem
A/C System High Pressure High Temperature Problem
PCM Stack Overrun Problem
Transmission Control Module Reprogrammable Memory Problem

Repair Processes :

With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. If you find a related TSB, the information will often help in diagnosing the code in question as TSBs are crested from many thousands of repairs. Look at the plug wires to make sure they are not burnt or laying on the exhaust.

Process Tips

Diagnostic trouble code C0331 Ford Probe Gt is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before C0331 Ford Probe Gt.

Fortunately, C0331 Ford Probe Gt is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.