C0221 Austin A30 Diagnostic Trouble Code

C0221 Austin A30 code definition:
C0221 is a kind of OBD-II Diagnostic C-Chassis Diagnostic Trouble Code for Austin A30.

C0221 Austin A30 is described as Fuel System Too Rich, which basically means bank 1's oxygen sensor has detected a rich condition of fuel. This means there's not enough oxygen in the exhaust from too much fuel being delivered into the air and gas mixture for combusion. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a C0221 Austin A30 diagnostic trouble code may include:
Place of C0221 in engine

Possible Causes :

  • An air leak forward of the DPF will change the sensor readings resulting in the code
  • Rusty exhaust systems, cracked exhaust manifolds or damaged or missing gaskets or donuts will cause air leaks.
  • Fuel with a large percentage of sulfur will clog the DPF quickly

Common Misdiagnoses

  1. Control Module Throttle Actuator Position Performance Problem
  2. Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
  3. Cruise Vehicle Speed/Set Speed Difference Too High Problem
  4. Kick-Down Switch Failed Short Problem
  5. Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit Problem

Repair Processes :

It should be pretty close to battery voltage (12 volts). If not, then this is the circuit that has the problem. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Look at the plug wires to make sure they are not burnt or laying on the exhaust.

Process Tips

Diagnostic trouble code C0221 Austin A30 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before C0221 Austin A30.

Fortunately, C0221 Austin A30 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

Diagnostic Trouble Code look-up and check engine light code viewer.

About Us | Contact | Privacy

Copyright 2024 - https://DiagnosticTrouble.com

Small Logo