B3611 Audi S1 Diagnostic Trouble Code

B3611 Audi S1 code definition:
B3611 is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Audi S1.

B3611 Audi S1 is described as Intake Air Temperature (IAT) Circuit Malfunction. It's actually a general trouble code for a problem on IAT electrical circuit sensor, as it sends incorrect voltage input signals to the PCM. Other symptoms that may indicate this problem are when the Check Engine Light illuminates and when there is a visible lack of engine power.

Symptoms

Symptoms of a B3611 Audi S1 diagnostic trouble code may include:

Poor acceleration
Cherry red hot catalytic converter
Possible spark knock (detonation / pre-ignition)
Engine surge

Possible Causes :

Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)
Rough running engine due to misfiring plugs. Many engines have misfire codes to indicate the cylinder effected, such as P0307 for number 7.
A large air leak at or near the number one oxygen sensor would also cause a lean mixture.

Common Misdiagnoses

TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem
Problem

Repair Processes :

Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Pack the connector cavity with dielectric silicone compound (same stuff they use for light bulb sockets and spark plug wires) and reassemble. Look at the plug wires to make sure they are not burnt or laying on the exhaust.

Process Tips

Diagnostic trouble code B3611 Audi S1 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B3611 Audi S1.

Fortunately, B3611 Audi S1 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.