B1940 Tatra T107 Diagnostic Trouble Code

B1940 Tatra T107 code definition:
B1940 is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Tatra T107.

B1940 Tatra T107 is described as Oxygen Sensor Circuit No Activity Detected (Bank 1, Sensor 1). This means there's a problem in the front oxygen sensor on Bank 1, as the O2 sensor is inactive. Other symptoms that may indicate this problem are when the Check Engine Light illuminates and when there is a visible lack of engine power.

Symptoms

Symptoms of a B1940 Tatra T107 diagnostic trouble code may include:

Engine surge
Blown fuse (if applicable)
Lack of power
Hesitation upon acceleration

Possible Causes :

Some aftermarket accessories and performance modifications
A faulty oxygen sensor. This will set a code in itself, however, a faulty oxygen sensor does not automatically condemn the sensor. The code just means that the sensor signal was not within specifications. An air leak or any of the above will cause an erroneous signal. There is a multitude of O2 codes relating to O2 performance which gives a clue to the problematic area.
Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)

Common Misdiagnoses

TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem
Problem

Repair Processes :

Oxygen sensors signal the engine management computer the amount of oxygen present in the exhaust, which is used in determining and controlling the fuel ratio. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. If the scan tool has that capability, and the scan tool can operate the IMRC valves, then the problem is either resolved and a simple code clearing is all that's left or a new PCM would be called for.

Process Tips

Diagnostic trouble code B1940 Tatra T107 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B1940 Tatra T107.

Fortunately, B1940 Tatra T107 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.