B1397 Subaru Pleo Diagnostic Trouble Code

B1397 Subaru Pleo code definition:
B1397 is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Subaru Pleo.

B1397 Subaru Pleo is triggered when the bank 1 camshaft position sensor doesn't match the signal from the crankshaft position sensor. The spark should have a light tan color. If the sensor probe comes with white and chalky parts, this means it has been lagging between switching phases, and should be replaced.

Symptoms

Symptoms of a B1397 Subaru Pleo diagnostic trouble code may include:

The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.
Faulty PCM
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
Diminished fuel efficiency

Possible Causes :

The Mass Airflow sensor is a hot wire that senses the volume of air entering the intake manifold. The computer uses this information to control fuel mixture.
Defective ECU strategies or components will prevent proper regeneration
An air leak forward of the DPF will change the sensor readings resulting in the code

Common Misdiagnoses

Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
Kick-Down Switch Failed Short Problem
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit Problem

Repair Processes :

Oxygen sensors signal the engine management computer the amount of oxygen present in the exhaust, which is used in determining and controlling the fuel ratio. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. You might continue by connecting the scanner to the vehicle diagnostic connector and retrieving all stored codes and freeze frame data.

Process Tips

Diagnostic trouble code B1397 Subaru Pleo is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B1397 Subaru Pleo.

Fortunately, B1397 Subaru Pleo is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.