B1347 Nissan 260 Diagnostic Trouble Code

B1347 Nissan 260 code definition:
B1347 is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Nissan 260.

B1347 Nissan 260 is defined as Knock Sensor Circuit Range Performance (Bank 1 or Single Sensor). This refers to camshaft timing, which in this case is over-retarded. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a B1347 Nissan 260 diagnostic trouble code may include:

Blown fuse (if applicable)
Engine surge
Reduction in engine performance, especially at low RPM levels
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected

Possible Causes :

A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
Faulty IMRC actuator relay (if equipped)
Dirty air cleaner element Damaged DPF

Common Misdiagnoses

Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
Kick-Down Switch Failed Short Problem
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit Problem

Repair Processes :

You might continue by connecting the scanner to the vehicle diagnostic connector and retrieving all stored codes and freeze frame data. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground.

Process Tips

Diagnostic trouble code B1347 Nissan 260 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B1347 Nissan 260.

Fortunately, B1347 Nissan 260 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.