B1048 Allard J2 Diagnostic Trouble Code

B1048 Allard J2 code definition:
B1048 is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Allard J2.

B1048 Allard J2 is defined as Cylinder 3 Injector Circuit Malfunction. This code means the PCM (powertrain control module, also known as ECM or engine control) has detected a problem in the injector or its wiring, or in injector circuit for cylinder 3. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a B1048 Allard J2 diagnostic trouble code may include:

Excessive exhaust leak
Hesitation upon acceleration
Malfunction Indicator Lamp (MIL) illuminated
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.

Possible Causes :

An air leak forward of the DPF will change the sensor readings resulting in the code
Rusty exhaust systems, cracked exhaust manifolds or damaged or missing gaskets or donuts will cause air leaks.
Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.

Common Misdiagnoses

IC Circuit High Voltage Problem
Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
PCM Stack Overrun Problem

Repair Processes :

It should be pretty close to battery voltage (12 volts). If not, then this is the circuit that has the problem. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector.

Process Tips

Diagnostic trouble code B1048 Allard J2 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B1048 Allard J2.

Fortunately, B1048 Allard J2 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.