B0149 Acura Loctite Diagnostic Trouble Code

B0149 Acura Loctite code definition:
B0149 is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Acura Loctite.

B0149 Acura Loctite or the Evaporative Emission Control System Incorrect Purge Flow is the set whenever the computer sees that there is a problem with the flow coming from the purge valve or the purge flow is not enough within the EVAP system. Other serious codes may cause this code to pop up, and they may come with dangerous drivability issues that may expose you to safety risks and cause damage to the engine in the long run.

Symptoms

Symptoms of a B0149 Acura Loctite diagnostic trouble code may include:
  • Poor acceleration
  • Cherry red hot catalytic converter
  • Possible spark knock (detonation / pre-ignition)
  • If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
Place of B0149 in engine

Possible Causes :

  • A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
  • Faulty IMRC actuator relay (if equipped)
  • A faulty oxygen sensor. This will set a code in itself, however, a faulty oxygen sensor does not automatically condemn the sensor. The code just means that the sensor signal was not within specifications. An air leak or any of the above will cause an erroneous signal. There is a multitude of O2 codes relating to O2 performance which gives a clue to the problematic area.

Common Misdiagnoses

  1. Control Module Throttle Actuator Position Performance Problem
  2. Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
  3. Cruise Vehicle Speed/Set Speed Difference Too High Problem
  4. Kick-Down Switch Failed Short Problem
  5. Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit Problem

Repair Processes :

It should be pretty close to battery voltage (12 volts). If not, then this is the circuit that has the problem. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Replace the oxygen sensor that is downstream from the catalytic converter on the side of the engine that does not contain cylinder #1. Also, if a oxygen sensor code stating "heater circuit malfunction" the sensor has most probably failed.

Process Tips

Diagnostic trouble code B0149 Acura Loctite is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B0149 Acura Loctite.

Fortunately, B0149 Acura Loctite is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

Diagnostic Trouble Code look-up and check engine light code viewer.

Copyright 2021 - https://diagnosticTrouble.com

Small Logo