B0109 Mg J4 Diagnostic Trouble Code

B0109 Mg J4 code definition:
B0109 is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Mg J4.

B0109 Mg J4 shows up when there's an electrical problem that causes the fuel volume regulator to malfunction and open. It's quite an unusual problem and likely intermittent. Other symptoms that may indicate this problem are when the Check Engine Light illuminates and when there is a visible lack of engine power.

Symptoms

Symptoms of a B0109 Mg J4 diagnostic trouble code may include:
Place of B0109 in engine

Possible Causes :

  • A faulty oxygen sensor. This will set a code in itself, however, a faulty oxygen sensor does not automatically condemn the sensor. The code just means that the sensor signal was not within specifications. An air leak or any of the above will cause an erroneous signal. There is a multitude of O2 codes relating to O2 performance which gives a clue to the problematic area.
  • Some aftermarket accessories and performance modifications
  • Faulty IMRC actuator/sensor

Common Misdiagnoses

  1. Vehicle Speed Output Circuit Problem
  2. Cruise Control Servo Indicates Low Problem
  3. A/C System High Pressure High Temperature Problem
  4. PCM Stack Overrun Problem
  5. Transmission Control Module Reprogrammable Memory Problem

Repair Processes :

With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Pack the connector cavity with dielectric silicone compound (same stuff they use for light bulb sockets and spark plug wires) and reassemble. Replace the oxygen sensor that is downstream from the catalytic converter on the side of the engine that does not contain cylinder #1. Also, if a oxygen sensor code stating "heater circuit malfunction" the sensor has most probably failed.

Process Tips

Diagnostic trouble code B0109 Mg J4 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B0109 Mg J4.

Fortunately, B0109 Mg J4 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

Diagnostic Trouble Code look-up and check engine light code viewer.

About Us | Contact | Privacy

Copyright 2024 - https://DiagnosticTrouble.com

Small Logo