B0108 Hyundai Galloper Diagnostic Trouble Code

B0108 Hyundai Galloper code definition:
B0108 is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Hyundai Galloper.

B0108 Hyundai Galloper is described as Oxygen Sensor Circuit No Activity Detected Bank 2 Sensor 1. This code appears when the PCM (powertrain control module, also known as ECM or engine control module in other brands) remains at or close the 0.450 set voltage point. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a B0108 Hyundai Galloper diagnostic trouble code may include:
Place of B0108 in engine

Possible Causes :

  • Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.
  • Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.
  • An air leak forward of the DPF will change the sensor readings resulting in the code

Common Misdiagnoses

  1. IC Circuit High Voltage Problem
  2. Control Module Throttle Actuator Position Performance Problem
  3. Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
  4. Cruise Vehicle Speed/Set Speed Difference Too High Problem
  5. PCM Stack Overrun Problem

Repair Processes :

Find out what kind of system you have and verify that voltage to the fuel level sensor is present at the fuel pump wiring harness. Oxygen sensors signal the engine management computer the amount of oxygen present in the exhaust, which is used in determining and controlling the fuel ratio. Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors. Pull the connectors apart and carefully look at the terminals (the metal parts) inside the connectors.

Process Tips

Diagnostic trouble code B0108 Hyundai Galloper is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B0108 Hyundai Galloper.

Fortunately, B0108 Hyundai Galloper is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

Diagnostic Trouble Code look-up and check engine light code viewer.

About Us | Contact | Privacy

Copyright 2024 - https://DiagnosticTrouble.com

Small Logo