B0022 Chevrolet Impala Diagnostic Trouble Code

B0022 Chevrolet Impala code definition:
B0022 is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Chevrolet Impala.

B0022 Chevrolet Impala is triggered when the bank 1 camshaft position sensor doesn't match the signal from the crankshaft position sensor. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a B0022 Chevrolet Impala diagnostic trouble code may include:
Place of B0022 in engine

Possible Causes :

  • Some aftermarket accessories and performance modifications
  • A faulty oxygen sensor. This will set a code in itself, however, a faulty oxygen sensor does not automatically condemn the sensor. The code just means that the sensor signal was not within specifications. An air leak or any of the above will cause an erroneous signal. There is a multitude of O2 codes relating to O2 performance which gives a clue to the problematic area.
  • An air leak forward of the DPF will change the sensor readings resulting in the code

Common Misdiagnoses

  1. Exhaust Gas Recirculation System Valve 1 Problem
  2. BBV Sensor Circuit Low Voltage Problem
  3. Transmission Engaged At High Throttle Angle Problem
  4. Cruise Inhibit Control Circuit Problem
  5. TFP Valve Position Switch-Drive Without Drive Ratio Problem

Repair Processes :

Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Once located, visually inspect the connectors and wiring. Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors.

Process Tips

Diagnostic trouble code B0022 Chevrolet Impala is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B0022 Chevrolet Impala.

Fortunately, B0022 Chevrolet Impala is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

Diagnostic Trouble Code look-up and check engine light code viewer.

About Us | Contact | Privacy

Copyright 2024 - https://DiagnosticTrouble.com

Small Logo